without other changes

This commit is contained in:
Sam Chin 2025-08-11 17:53:47 +08:00
parent b32fa12da8
commit e954ca60e2

View file

@ -686,46 +686,6 @@ bio_code!(pin_control_code, PIN_CONTROL_START, PIN_CONTROL_END,
// Loop back to wait for the next command.
"j wait_for_cmd"
);
#[rustfmt::skip]
bio_code!(pin_read_write_code, PIN_RW_START, PIN_RW_END,
// This program waits for three words from the CPU:
// 1. Write Pin Mask (the pin to set as output)
// 2. State Value (0 for LOW, 0xFFFFFFFF for HIGH)
// 3. Read Pin Mask (the pin to read from)
// It then performs the write, reads the input pin,
// and sends the result (0 or non-zero) back to the CPU.
"wait_for_cmd:",
// --- Receive parameters from the CPU ---
"mv t1, x16", // t1 = Write Pin Mask
"mv t2, x16", // t2 = State Value
"mv t3, x16", // t3 = Read Pin Mask
// --- Configure Pin Directions ---
// Set the write pin as an OUTPUT (bit = 1) and all others as INPUT (bit = 0).
"mv x24, t1",
// --- Perform the Write Operation ---
// Set the GPIO mask register to the write pin.
"mv x26, t1",
// Set the output register to the desired state.
"mv x21, t2",
// --- Perform the Read Operation ---
// Read the state of all input pins into t4.
"mv t4, x25",
// Isolate the bit for the specific pin we want to read.
"and t5, t4, t3", // t5 = (value of all pins) & (read pin mask)
// --- Send Result Back to CPU ---
// Write the result (t5) to the transmit FIFO (x17).
// The CPU will read this value.
"mv x17, t5",
// Loop back to wait for the next command.
"j wait_for_cmd"
);
#[rustfmt::skip]
bio_code!(simple_test_code, SIMPLE_TEST_START, SIMPLE_TEST_END,
"li sp, 0x800",