diff --git a/baremetal/src/repl.rs b/baremetal/src/repl.rs index 618316cf7..fb9a4ecd9 100644 --- a/baremetal/src/repl.rs +++ b/baremetal/src/repl.rs @@ -686,46 +686,6 @@ bio_code!(pin_control_code, PIN_CONTROL_START, PIN_CONTROL_END, // Loop back to wait for the next command. "j wait_for_cmd" ); - -#[rustfmt::skip] -bio_code!(pin_read_write_code, PIN_RW_START, PIN_RW_END, - // This program waits for three words from the CPU: - // 1. Write Pin Mask (the pin to set as output) - // 2. State Value (0 for LOW, 0xFFFFFFFF for HIGH) - // 3. Read Pin Mask (the pin to read from) - // It then performs the write, reads the input pin, - // and sends the result (0 or non-zero) back to the CPU. - "wait_for_cmd:", - // --- Receive parameters from the CPU --- - "mv t1, x16", // t1 = Write Pin Mask - "mv t2, x16", // t2 = State Value - "mv t3, x16", // t3 = Read Pin Mask - - // --- Configure Pin Directions --- - // Set the write pin as an OUTPUT (bit = 1) and all others as INPUT (bit = 0). - "mv x24, t1", - - // --- Perform the Write Operation --- - // Set the GPIO mask register to the write pin. - "mv x26, t1", - // Set the output register to the desired state. - "mv x21, t2", - - // --- Perform the Read Operation --- - // Read the state of all input pins into t4. - "mv t4, x25", - // Isolate the bit for the specific pin we want to read. - "and t5, t4, t3", // t5 = (value of all pins) & (read pin mask) - - // --- Send Result Back to CPU --- - // Write the result (t5) to the transmit FIFO (x17). - // The CPU will read this value. - "mv x17, t5", - - // Loop back to wait for the next command. - "j wait_for_cmd" -); - #[rustfmt::skip] bio_code!(simple_test_code, SIMPLE_TEST_START, SIMPLE_TEST_END, "li sp, 0x800",