add pddb erase on altboot for oem mode

This commit is contained in:
bunnie 2026-06-15 23:03:20 +08:00
parent 8964027fff
commit 0dc2c133f5

View file

@ -249,6 +249,72 @@ pub fn early_init(mut board_type: bao1x_api::BoardTypeCoding) -> (bao1x_api::Boa
// power on
iox.set_gpio_pin_value(oled_on_port, oled_on_pin, IoxValue::High);
#[cfg(feature = "alt-boot1")]
{
crate::println!("entering pddb_erase");
// setup all the board pins to a known state
let iox = Iox::new(utra::iox::HW_IOX_BASE as *mut u32);
bao1x_hal::board::setup_memory_pins(&iox);
// this routine is used to initialize baosec products - sets the board type and
// erases the off-chip FLASH
use bao1x_api::baosec::PDDB_ORIGIN;
use bao1x_hal::{
board::SPINOR_BULK_ERASE_SIZE,
ifram::IframRange,
iox::Iox,
udma::{Spim, *},
};
let perclk = 100_000_000;
let udma_global = GlobalConfig::new();
// setup the I/O pins
let channel = bao1x_hal::board::setup_memory_pins(&iox);
udma_global.clock_on(bao1x_api::PeriphId::from(channel));
// safety: this is safe because clocks have been set up
let mut flash_spim = unsafe {
Spim::new_with_ifram(
channel,
// has to be half the clock frequency reaching the block, but
// run it as fast
// as we can run perclk
perclk / 4,
perclk / 2,
SpimClkPol::LeadingEdgeRise,
SpimClkPha::CaptureOnLeading,
SpimCs::Cs0,
0,
0,
None,
256 + 16, /* just enough space to send commands + programming
* page */
4096,
Some(6),
Some(SpimMode::Standard), // guess Standard
IframRange::from_raw_parts(
bao1x_hal::board::SPIM_FLASH_IFRAM_ADDR,
bao1x_hal::board::SPIM_FLASH_IFRAM_ADDR,
4096 * 2,
),
)
};
flash_spim.identify_flash_reset_qpi();
let flash_id = flash_spim.mem_read_id_flash();
crate::println!("flash ID (init): {:x}", flash_id);
if bao1x_api::SPI_FLASH_IDS.contains(&(flash_id & 0xFF_FF_FF)) {
let pddb_erase_len = SPINOR_BULK_ERASE_SIZE as usize * 2;
for addr in
(PDDB_ORIGIN..PDDB_ORIGIN + pddb_erase_len).step_by(SPINOR_BULK_ERASE_SIZE as usize)
{
crate::println!(" {:x}...", addr);
flash_spim.flash_erase_block(addr, SPINOR_BULK_ERASE_SIZE as usize);
}
crate::println!("...done!");
} else {
crate::println!("...skipped, couldn't find FLASH part");
}
}
}
#[cfg(not(feature = "oem"))]
BoardTypeCoding::Oem => {