diff --git a/bao1x-boot/boot1/src/platform/bao1x/usb/driver.rs b/bao1x-boot/boot1/src/platform/bao1x/usb/driver.rs index 46d9a5658..cebd1c2a1 100644 --- a/bao1x-boot/boot1/src/platform/bao1x/usb/driver.rs +++ b/bao1x-boot/boot1/src/platform/bao1x/usb/driver.rs @@ -29,6 +29,41 @@ pub unsafe fn init_usb() { disk[offset..offset + 32].copy_from_slice(&block); } + // Windows uses the MBR disk signature (0x1b8) to deduplicate volumes; two boards + // with the same signature cannot both receive a drive letter simultaneously. Derive + // all three fields (MBR disk sig, primary and backup FAT VSN) from the per-device + // UUID so each board is unique. + { + let owc = bao1x_hal::acram::OneWayCounter::new(); + let slot_mgr = bao1x_hal::acram::SlotManager::new(); + let sn = bao1x_hal::usb::derive_usb_serial_number(&owc, &slot_mgr); + // XOR-fold all 6 serial-number bytes into 4 VSN bytes so every bit of the + // UUID-derived string contributes to the VSN. + let mut vsn = [0u8; 4]; + for (i, &b) in sn.as_bytes().iter().enumerate() { + vsn[i % 4] ^= b; + } + // 0x1b8 is the MBR disk signature per https://wiki.osdev.org/MBR_(x86) + const MBR_DISK_SIG: usize = 0x1b8; + // The value of this constant depends upon the value written into the + // partition table. The partition start is defined here: + // 0x1C6: 80 00 00 00 <- LBA of partition start = 0x00000080 = 128 + // 128 (sectors) * 512 (bytes/sector) = 0x1_0000. + // Starting at 0x43 there is the "BS_VolID" or "VSN" record, 4 bytes long. + // The backup VBR is, by spec, located at 6 sectors from the partition + // start. 6 * 512 = 3072 = 0xc00, hence 0x1_c000 as its base offset. + // + // The pokes below stick the same derived 4-byte value into these three + // fields, which helps Windows differentiate between multiple Baochip + // devices mounted, with a 2^16 chance of collision per the birthday + // paradox, given a 32-bit randomly generated ID. + const PRIMARY_VBR_VSN: usize = 0x1_0043; + const BACKUP_VBR_VSN: usize = 0x1_0c43; + disk[MBR_DISK_SIG..MBR_DISK_SIG + 4].copy_from_slice(&vsn); + disk[PRIMARY_VBR_VSN..PRIMARY_VBR_VSN + 4].copy_from_slice(&vsn); + disk[BACKUP_VBR_VSN..BACKUP_VBR_VSN + 4].copy_from_slice(&vsn); + } + // install the interrupt handler // setup the stack & controller // irq_setup(); // this is already assumed to have been called by early_init()!