improve formatting & timing slightly

This commit is contained in:
bunnie 2026-01-06 15:43:50 +08:00
parent d1a3eb4b58
commit 079ec33134

View file

@ -171,7 +171,7 @@ bio_code!(ws2812b_kernel, WS2812B_START, WS2812B_END,
// LEDs will go onto the stack
"li x9, 0x1000000", // bit 24 mask
"li sp, 0x800", // start of the LED buffer
"10:",
"10:",
// read a 24-bit color number from FIFO1
"mv x8, x17",
"sw x8, 0(sp)",
@ -181,19 +181,24 @@ bio_code!(ws2812b_kernel, WS2812B_START, WS2812B_END,
"j 10b", // go back and get more data
// -- sending loop --
"20:",
"20:",
"li x8, 0x800", // x8 now has the starting address of the data we're going to send
// x9 is the bit 24 mask used by the above loop
"li x12, 0x800000", // bit 23 mask
// loop setup done
"30:",
"30:",
"li x11, 24", // number of bits to shift through
"lw x10, 0(x8)", // fetch the word to send
// "mv x18, x10", // debug by looping back -----------
"31:",
"31:",
"and x13, x12, x10", // the bit we're contemplating is at bit 23 position, extract it into x13
"bne x13, x0, 40f", // if 1, go to 40f, where the 1 routine is
"mv x20, x0", // snap to quantum before doing the send routine - this improves timing uniformity of high pulses
// at the expense of T1L time being a little out of spec, but this is better-tolerated than T0H time being variable.
// this quantum snap has to be introduced here because snap quantum to output makes the ws2812 driver not
// composable with other BIO applications
// zero routine
// 2 hi
"mv x22, x4", // sets to 1
@ -214,7 +219,7 @@ bio_code!(ws2812b_kernel, WS2812B_START, WS2812B_END,
"j 50f", // jump to the loop end check
// one routine
"40:",
"40:",
// 7 hi
"mv x22, x4", // sets to 1
"mv x20, x0", // wait for quantum
@ -232,16 +237,16 @@ bio_code!(ws2812b_kernel, WS2812B_START, WS2812B_END,
"addi x11, x11, -1", // decrement the pixel bit counter
"mv x20, x0",
"50:", // shift and do the next pixel value
"50:", // shift and do the next pixel value
"bne x11, x0, 31b", // go back for more in the loop
"60:", // check if we've exhausted all the LED values
"60:", // check if we've exhausted all the LED values
"addi x8, x8, 4",
"bge sp, x8, 30b", // see if we've hit the value of current sp
"li sp, 0x800", // reset the stack pointer for a fresh fetch
// wait to reset the chain
"li x14, 2000", // delay wait time to reset the chain per spec
"70:",
"70:",
"addi x14, x14, -1",
"mv x20, x0",
"bne x14, x0, 70b",