This changes the sorting algorithm for the xport<->SFP mapping. When
multiple SFPs are used, this sorting will avoid a criss-cross mapping
(e.g., mapping ports 0 and 1 of 0/Radio_0 to different SFPs).
- Replace mykonos finish_initialization with async version
- Replace myknonos setup_cal with async version
- Remove disable_timeout on rpc_server init()
Usually, the current timeout is fine, but there are cases when a lot of
RPC traffic could drown out the reclaim calls. 5 seconds is an
experimentally derived safe value.
Separating Boost.Python bindings into device-specific files. N3XX code
now lives in n3xx/pyusrp_periphs. Only one src file should be added for
pyusrp_periphs.so by CMake.
Bump maximum supported motherboard revision to 5 (RevF),
to support upcoming motherboard revisions.
Signed-off-by: Moritz Fischer <moritz.fischer@ettus.com>
Adding address offset to all MBoard and DBoard EEPROM reads. This
matches what we're doing for the user portion of the EEPROM, and
allows us to share access to an EEPROM.
UIO objects now count references on open and close calls. This should
prevent problems with nested function calls that open/close the same
UIO object.
References counts are not atomic -- this is intended for nesting with
statements within the same thread context.
Reviewed-by: Martin Braun <martin.braun@ettus.com>
Reviewed-by: Trung Tran <trung.tran@ettus.com>
The log output at level 'INFO' was pretty cluttered. This cleans up the
log messages at the higher levels. In some cases, log message typos or
capitalizations were also fixed.
The FPGA and MPM version as well as the description of the device
("N300-Series Device") and its name (its the hostname) are now properly
reported coming from MPM, properly saved in the prop tree, and
uhd_usrp_probe can nicely display them this way.
-Adding MboardRegsControl.get_fpga_type(), which reads the SFP info
registers and determines the FPGA image type (HG, XG, AA, etc). This is
a minor FPGA compat number bump.
-Adding N310._update_fpga_type(), which updates the component
information using the get_fpga_type() function described above. This
information can then be accessed through get_component_info().
The lines removed here are no longer needed, get rid of them
Suggested-by: Martin Braun <martin.braun@ettus.com>
Signed-off-by: Moritz Fischer <moritz.fischer@ettus.com>
In order to match the front panel 0 and 1 for the SFPs, as well as for
clarity and consistency reasons, udev rules will be put onto future
filesystems in order to rename the eth1 eth2 devices to sfp0 and sfp1.
This change *should* be backwards compatible, nevertheless, be careful
and bump compat number.
This also updates the uhd image loader manifest.
Signed-off-by: Moritz Fischer <moritz.fischer@ettus.com>
