Introduce dt-compat and mcu-compat fields into the eeprom
structure.
For the motherboard eeprom this is straightforward, since
there's still padding bytes that could be (ab)used for this.
On the dboard side more creativity is required and the
original revision field of 2 bytes is reduced to only
one byte revision and one byte dt-compat.
Since this will only affect new units being backwards
compatible with older versions of the bootloader is not
an issue.
Reviewed-by: Brent Stapleton <brent.stapleton@ettus.com>
Signed-off-by: Moritz Fischer <moritz.fischer@ettus.com>
This manager first detects all valid Ethernet devices. The checks for
validity happen across multiple calls in a non-atomic fashion, so it's
possible to end up with inconsistent results. To avoid such issues, we
filter results without talking to the network stack as a final pass.
Because the detection of valid Ethernet devices happens across multiple
calls in a non-atomic fashion, we cannot assume that a device passed to
net.get_iface_info() actually has a valid IP address, so we don't make
that assumption.
Since there is no simple mapping from an arbitrary tuple of mboard- and
dboard info dictionaries, we use generate_device_info() to figure out
the product key.
In the N3xx series, the motherboard ID and the device ID can differ. For
example, the N310 could share the same motherboard with a different
device that uses different daughterboards.
This changes the sorting algorithm for the xport<->SFP mapping. When
multiple SFPs are used, this sorting will avoid a criss-cross mapping
(e.g., mapping ports 0 and 1 of 0/Radio_0 to different SFPs).
- Replace mykonos finish_initialization with async version
- Replace myknonos setup_cal with async version
- Remove disable_timeout on rpc_server init()
Usually, the current timeout is fine, but there are cases when a lot of
RPC traffic could drown out the reclaim calls. 5 seconds is an
experimentally derived safe value.
Separating Boost.Python bindings into device-specific files. N3XX code
now lives in n3xx/pyusrp_periphs. Only one src file should be added for
pyusrp_periphs.so by CMake.
Bump maximum supported motherboard revision to 5 (RevF),
to support upcoming motherboard revisions.
Signed-off-by: Moritz Fischer <moritz.fischer@ettus.com>
Adding address offset to all MBoard and DBoard EEPROM reads. This
matches what we're doing for the user portion of the EEPROM, and
allows us to share access to an EEPROM.
UIO objects now count references on open and close calls. This should
prevent problems with nested function calls that open/close the same
UIO object.
References counts are not atomic -- this is intended for nesting with
statements within the same thread context.
Reviewed-by: Martin Braun <martin.braun@ettus.com>
Reviewed-by: Trung Tran <trung.tran@ettus.com>
The log output at level 'INFO' was pretty cluttered. This cleans up the
log messages at the higher levels. In some cases, log message typos or
capitalizations were also fixed.
The FPGA and MPM version as well as the description of the device
("N300-Series Device") and its name (its the hostname) are now properly
reported coming from MPM, properly saved in the prop tree, and
uhd_usrp_probe can nicely display them this way.
